Re: Windows 2016 Server: [!] bind: Address already in use (WSAEADDRINUSE) (10048)
Małgorzata Olszówka <[email protected]>
| Newsgroups | gmane.network.stunnel.user |
|---|---|
| Message-ID | <[email protected]> |
> If I run stunnel I regular get the below error: ... > >>> [!] bind: Address already in use (WSAEADDRINUSE) (10048) <<<< > [!] Error binding service [smtps] to 192.168.10.62:11465 > <http://192.168.10.62:11465> > [!] Could not bind any accepting port ... > > I had the same problem with the previous versions aswell. > > To temporary resolv the problem I have to change the listen port to > another number. Reread the config file and let the stunnel GUI open. > Then all is working until I close the GUI (not each time but most of). > My system: > - Windows 2016 Server > - stunnel-5.46 > - stunnel installed as service and GUI > Hello Martin, Could open up a command prompt in Administrator mode and type „neststat -abn” in order to find out which process is listening upon the selected port? Maybe stunnel service is working? Regards, Małgorzata _______________________________________________ stunnel-users mailing list [email protected] https://www.stunnel.org/cgi-bin/mailman/listinfo/stunnel-users