Silent Install Problem
Thane Sherrington <[email protected]>
| Newsgroups | gmane.network.tight-vnc.general |
|---|---|
| Message-ID | <[email protected]> |
Hello all,
With tightvnc-2.7.10-setup-32bit.msi, I was able to use the command:
msiexec /i tightvnc-2.7.10-setup-32bit.msi /quiet /norestart
ADDLOCAL="Server" SERVER_REGISTER_AS_SERVICE=1
SERVER_ADD_FIREWALL_EXCEPTION=1 SERVER_ALLOW_SAS=1
SET_USEVNCAUTHENTICATION=1 VALUE_OF_USEVNCAUTHENTICATION=1
SET_PASSWORD=1 VALUE_OF_PASSWORD=XXX SET_USECONTROLAUTHENTICATION=1
VALUE_OF_USECONTROLAUTHENTICATION=1 SET_CONTROLPASSWORD=1
to install TightVNC server and set the password and it worked perfectly.
I switched to tightvnc-2.8.5-gpl-setup-32bit.msi and the install
works, but it says "Password not set" and I can't connect.
Is there a way to fix this?
Thanks,
Thane
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
___________________________________________________________
TightVNC mailing list, [email protected]
To change your subscription or to UNSUBSCRIBE, please visit
https://lists.sourceforge.net/lists/listinfo/vnc-tight-list