v2.8.5 Windows 10 - server is not correctly configured
Ryan Plieth <[email protected]>
| Newsgroups | gmane.network.tight-vnc.general |
|---|---|
| Message-ID | <MWHPR19MB1456938F034F76A0BDAB44A1BB980@MWHPR19MB1456.namprd19.prod.outlook.com> |
Hi, I am hoping someone can help explain why the MSI install switches that worked in the past with v2.7 are not working with Windows 10? I end up getting a "server is not configured correctly" in the app event log. What ends up resolving it is going into the TightVNC Service Configuration (Offline) and manually inputting the primary password under Server tab. msiexec /i "tightvnc-2.8.5-gpl-setup-64bit.msi" /quiet /norestart SET_USEVNCAUTHENTICATION=1 VALUE_OF_USEVNCAUTHENTICATION=1 SET_PASSWORD=1 VALUE_OF_PASSWORD=****** SET_USECONTROLAUTHENTICATION=1 VALUE_OF_USECONTROLAUTHENTICATION=1 SET_CONTROLPASSWORD=1 VALUE_OF_CONTROLPASSWORD=****** SET_REMOVEWALLPAPER=1 VALUE_OF_REMOVEWALLPAPER=0 SET_RUNCONTROLINTERFACE=1 VALUE_OF_RUNCONTROLINTERFACE=0 SET_IPACCESSCONTROL=1 VALUE_OF_IPACCESSCONTROL="0.0.0.0-255.255.255.255:0" ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot ___________________________________________________________ TightVNC mailing list, [email protected] To change your subscription or to UNSUBSCRIBE, please visit https://lists.sourceforge.net/lists/listinfo/vnc-tight-list