Re: Error in TightVNC Viewer: Connection parameters...

Here attached is a test .vnc file

I receive the "Error in TightVNC Viewer:..." error when running Viewer 
version 2.7.10 or 2.8.8.

Interestly, it's only on this one Windows 10, 64 bit box, whereas other 
similiar boxes it works fine.

The viewer connects no problem, but after saving to a .vnc file, when
launching I get this "Error in TightVNC Viewer: Connection parameters
(host, port, sockdt, gates) is empty."

Tom


On 07/20/2017 09:52 PM, Constantin Kaplinsky wrote:
> Hello Tom,
> 
> Please try the latest version, 2.8.8. If the problem is still there,
> please send us a .vnc file which causes the problem to
> [email protected] (make sure NOT to save the password into that .vnc
> file).
> 
> Thank you.
>

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot

___________________________________________________________
TightVNC mailing list, [email protected]
To change your subscription or to UNSUBSCRIBE, please visit
https://lists.sourceforge.net/lists/listinfo/vnc-tight-list

[connection]
host=192.168.101.101
port=5901
[options]
use_encoding_1=1
copyrect=1
viewonly=0
fullscreen=0
8bit=0
shared=1
belldeiconify=0
disableclipboard=0
swapmouse=0
fitwindow=0
cursorshape=1
noremotecursor=0
preferred_encoding=7
compresslevel=-1
quality=6
localcursor=1
scale_den=1
scale_num=1
local_cursor_shape=1