Re: tin-2.2.1 does not compile

Ulli Horlacher <[email protected]>
Newsgroups gmane.network.tin.bugs
Message-ID <[email protected]>
On Sun 2015-04-26 (00:40), Urs Janßen wrote:
> On Sat, Apr 25, 2015 at 10:33:18PM +0200, Ulli Horlacher wrote:
> > root@fex:/opt/src/tin-2.2.1# ./configure --prefix=/opt/tin-2.2.1 --enable-nntp-only
> > (...)
> 
> there should have been a warning about missing yacc or byacc or bison.

I have not seen such a warning.
Shouln't configure then terminate with an error?


> install any of the mention programms and rerun configure again after
> make distclean.

Ok, I have installed bison now, but after rerunning configure I see:

configure: warning: no term-lib found, you might run into trouble later.

What does this mean?



-- 
Ullrich Horlacher              Server und Virtualisierung
Rechenzentrum IZUS/TIK         E-Mail: [email protected]
Universitaet Stuttgart         Tel:    ++49-711-68565868
Allmandring 30a                Fax:    ++49-711-682357
70550 Stuttgart (Germany)      WWW:    http://www.tik.uni-stuttgart.de/
REF:<[email protected]>

_______________________________________________
tin-bugs mailing list
[email protected]
http://lists.tin.org/cgi-bin/mailman/listinfo/tin-bugs
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.