Re: Bug

On Wed, Jun 30, 2004 at 03:07:32PM +0200, Christian Knoke wrote:
> > > in Version: 1.7.5 Ausgabe 20040615 ("Gighay") Jun 15 2004 13:25:07
> > > (Debian Sarge), the mail thread command doesn't work any more. It performs
> > > mail artikel instead.
> > I can't reproduce this (tested from group, thread and article level),
> > could you give some more informations how to reproduce the bug?
> Well, I read an artikel that is part of a thread, then 'm', then 't'.
> At this point it shows: "Mailt Artikel an " and not "Mailt Thread an"
> (german locale here). I believe, it formerly used to show the latter.

I don't think so, but I didn't check that.

> I go 'e' edit mode then and see only one articel in the editor.

I see, you only get the first article in the editor, but all
articles in the thread are mailed. either we should give the user the
ability to edit each article in the editor sequentially or pull all articles
in the editor at once (and wrap them in message/rfc822)

urs
-- 
"Only whimps use tape backup: _real_ men just upload their important stuff
 on ftp, and let the rest of the world mirror it ;)" - Linus