Re: Problems running Tux w/ 2.4.19 generic
Shane Allen <[email protected]>
| Newsgroups | gmane.network.tux |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Jan 08, 2003 at 05:57:48PM -0600, [email protected] wrote: > Hello, > > I am currently trying to run Red Hat 8.0 with Tux compiled into a 2.4.19 generic kernel. I have applied the tux2-full-2.4.18-final-A3 patch. Under what I consider is very minor work loads Tux will, for apparently no reason, drop all of its threads and stop responding to requests. I realize that the patch was not intended for this kernel version, but it is necessary in order for my SMP machine to work properly. > > My question is this. > Has anyone attempted to do this, and if so did you see the same problems? If you didn't see the same problems, am I missing something? If you did see the same problems, did you ever find a work around for this issue? > > Thanks. Joshua Did you use a patch that had been ported to 2.4.19? When you patched, were there any error messages saying "Hunk #N Failed" where N is an integer? I've patched 2.4.21pre2 with tux, but I had to modify the patch in order to make the patching successful. Also, there have been numerous threads on-list regarding tux hanging with logging enabled. Check the archives for that info, and try disabling logging if you have it enabled. -- Shane Allen <[email protected]>