RE: Re: Engenius/Senao AP/Bridge - any comments?
"Frank Keeney" <[email protected]>
| Newsgroups | gmane.network.wireless.bay-area |
|---|---|
| Message-ID | <[email protected]> |
My Senao 2611 AP works perfectly. It replaced an older Linksys in my house. I've used it with Cisco, Lucent, Senao and Linksys cards successfully. I can use it all the way from across the street to the far end of my back yard. Perhaps your unit is defective? Frank Keeney Tel: 888-259-5110 x0 ---------------------------------- Wireless Antennas, Cables and Equipment: http://www.wlanparts.com > -----Original Message----- > On Behalf Of Dustin Moore > > I got a Senao 2611 AP with the hopes of using it on medium distance > (several hundred feet) links but I found that mine had a noisy RF > output. Every client card I tested it with had a very difficult time > reading the signal and many of them reported very high noise figures > (as high or higher than the signal!). I've mentioned this before > on the list, I believe. > _______________________________________________ BAWUG's general wireless chat mailing list [unsubscribe] http://lists.bawug.org/mailman/listinfo/wireless