RE: WAP11 hack

Hi

I agree but even v2.6 wasn't stable for me until I loaded the original ATMEL
firmware on it. Maybe now that Cisco owns Linksys we can expect v3 to be
stable when it comes out one day.

-Stefan 

> 
> Dear BAWUG,
> i see more people need the information about Linksys WAP11 
> components by their versions. Please find below the right 
> inside information:
> WAP11 v2.8 used the RFMD RF3000 BBP(baseband proc.) with RFMD 
> RF compomnent and ADMTek controller .
> WAP11 v2.6 used the RFMD RF3000 BBP with RFMD RF compomnent 
> and Atmel  controller.
> WAP11 v2.2 used the TI ACX100 BBP with TI RF component and 
> Samsung controller.
> WAP11 v1.1 used the Intersil PrismII BBP with Intersil RF 
> component and Atmel controller (2MB SRAM
> ver.)
> WAP11 v1.0 used the Intersil PrismII BBP with Intersil RF 
> component and Atmel controller (1MB SRAM
> ver.)
> 
> We tested all versions of WAP11, and i can really say that 
> only WAP11 v2.6 is very fine and stable access point. All 
> others, especially WAP11 v2.8 had more problems


_______________________________________________
BAWUG's general wireless chat mailing list
[unsubscribe] http://lists.bawug.org/mailman/listinfo/wireless