Re: Would Cisco POE kit for 1100 &1200 AP's work w/WRT54GS?

Linksys WRT54GS does not natively support POE, however you can make your 
own and run the power on the unused pairs. http://www.nycwireless.net/poe/

It's generally not good to cross-post in the same email, as I've 
learned. Make separate emails for each list.

Sean

crispin wrote:

>     Here's the description from the site...
>
> Provide up to 15 watts (depending on Cisco power supply model used) 
> over the unused wire pairs of a Category 5 Ethernet cable, supplying 
> enough power to provide for up to a 100-meter cable run
>
> Now that Cisco owns Linksys, I wouldn't be surprised if this might 
> work.  Not that familiar w/Linksys AP's, I don't dwell in that realm.  
> I see the Liknksys POE kit on the same site doesn't list the WRT's 
> among the compatible units.
>
>
> _______________________________________________
> BAWUG's general wireless chat mailing list
> [unsubscribe] http://lists.bawug.org/mailman/listinfo/wireless
>

_______________________________________________
BAWUG's general wireless chat mailing list
[unsubscribe] http://lists.bawug.org/mailman/listinfo/wireless