Re: prism2 silence value question

In message: <[email protected]>
            Rob Deker <[email protected]> writes:
: My values for silence however are (again, in my lab) ranging from ~30 to
: ~38 on average. This roughly seems to bear out the floor value of 27 that
: a lot of people seem to use, but I'm confused as to why I'm getting these
: different values from 2 cards with the same chipset and firmware versions.
: 
: Any thoughts from the peanut gallery?

My guess is that there's an external amplifier on the 200mW card and
there isn't on the netgear card.  This "distorts" the power levels and
thus the measurement of the signal/silence levels.

: Alternately, any suggestions on a good way to normalize the data I'm
: getting so that either card would be useful?

Good luck.  I've tried to come up with a good formula for this that
works for my 10 cards and have failed.

Warner