Re: bsd-airtools on openbsd 3.2

It detects as a wi0 on my Dell with OpenBSD 3.2. OpenBSD has detected a 
Cisco 340 a 350 and an Orinoco Gold card on install and they all worked 
great. None of these could install a functioning setup with any of those 
cards, Redhat 8.0, Mandrake 9.0, Debian 3 and FreeBSD 4.6. Drove me nuts.

The bsd-airtools package from the ports collection seems to work. I've 
been unable to get the source to compile though so I run the package.

Tye

Russell wrote:

> I thought a cisco 350 card was detected as an0 ?
> (at least it is in FreeBSD)
> I have so far been unable to get a cisco card
> working with the bsd-airtools software..  I've
> volunteered access to a development machine with
> the card installed, but have never gotten a response.
>
> See previous thread:
> Re: [BAT] cisco aironet support
> 1/17/2003
>
> -Russell
>
> At 03:30 PM 2/23/2003 -0600, you wrote:
>
>> Make sure the card is 'UP'.  On my rig it's only for sniffing so it's 
>> basically not configured with an ip or anything so I do an 'ifconfig 
>> wi0 up.' You also need to put it in monitor mode. I use "prism2ctl 
>> wio -m".
>>
>> My system is a dell inspiron 7000 with a cisco 350 card. OpenBSD 3.2.
>>
>> tye
>>
>> Nick Vahalik wrote:
>>
>>> Hey all,
>>>
>>>
>>> I'm trying to get my wlan card to work with dstumbler, but I am 
>>> having some problems.  The network card I am using is the Dell 
>>> Truemobile 1150:
>>>
>>> wi0 at pcmcia1 function 0 "Dell, TrueMobile 1150 Series PC Card, 
>>> Version 01.01" port 0x400/64: irq 9
>>> wi0: Firmware 8.10 variant 1, address 00:02:2d:51:38:15
>>>
>>> I installed OpenBSD 3.2 (no patches or updated wicontrol) from the 
>>> cdrom as an upgrade from 3.1 (X kept locking up with apmd).  I 
>>> installed the bsd-airtools-0.2.tgz package from the OpenBSD packages 
>>> page.  It installed with no problems.  So, I tried dstumbler: "# 
>>> dstumbler wi0<enter>", and it came up... but nothing happened.  The 
>>> lights on the card don't flash, and the only output I get is  
>>> "error: unable to ioctl device socket: Invalid argument" when I quit 
>>> dstumbler.  Do I need to use OpenBSD 3.0 and apply the patches to 
>>> get it to work?  Or do I need to get invest in a new wlan card?  
>>> maybe one of those wpc11's from Linksys?
>>>
>>> Thanks
>>> Nick
>>>
>>> _______________________________________________
>>> Bat mailing list
>>> [email protected]
>>> http://lists.dachb0den.com/mailman/listinfo/bat
>>
>>
>>
>>
>>
>> _______________________________________________
>> Bat mailing list
>> [email protected]
>> http://lists.dachb0den.com/mailman/listinfo/bat
>
>
> _______________________________________________
> Bat mailing list
> [email protected]
> http://lists.dachb0den.com/mailman/listinfo/bat