Re: bsd-airtools on openbsd 3.2
"Tye F. Hammerle" <[email protected]> Mon, 24 Feb 2003 19:37:15 -0600
| Newsgroups | gmane.network.wireless.bsd.airtools |
|---|---|
| Message-ID | <[email protected]> |
Oops, Bum dope alert! :( My lab target PC is the Cisco 350. The OpenBSD box is running a LinkSys WPC11. Sorry about that. The rest of the story is still good though. Tye Russell wrote: > I thought a cisco 350 card was detected as an0 ? > (at least it is in FreeBSD) > I have so far been unable to get a cisco card > working with the bsd-airtools software.. I've > volunteered access to a development machine with > the card installed, but have never gotten a response. > > See previous thread: > Re: [BAT] cisco aironet support > 1/17/2003 > > -Russell > > At 03:30 PM 2/23/2003 -0600, you wrote: > >> Make sure the card is 'UP'. On my rig it's only for sniffing so it's >> basically not configured with an ip or anything so I do an 'ifconfig >> wi0 up.' You also need to put it in monitor mode. I use "prism2ctl >> wio -m". >> >> My system is a dell inspiron 7000 with a cisco 350 card. OpenBSD 3.2. >> >> tye >> >> Nick Vahalik wrote: >> >>> Hey all, >>> >>> >>> I'm trying to get my wlan card to work with dstumbler, but I am >>> having some problems. The network card I am using is the Dell >>> Truemobile 1150: >>> >>> wi0 at pcmcia1 function 0 "Dell, TrueMobile 1150 Series PC Card, >>> Version 01.01" port 0x400/64: irq 9 >>> wi0: Firmware 8.10 variant 1, address 00:02:2d:51:38:15 >>> >>> I installed OpenBSD 3.2 (no patches or updated wicontrol) from the >>> cdrom as an upgrade from 3.1 (X kept locking up with apmd). I >>> installed the bsd-airtools-0.2.tgz package from the OpenBSD packages >>> page. It installed with no problems. So, I tried dstumbler: "# >>> dstumbler wi0<enter>", and it came up... but nothing happened. The >>> lights on the card don't flash, and the only output I get is >>> "error: unable to ioctl device socket: Invalid argument" when I quit >>> dstumbler. Do I need to use OpenBSD 3.0 and apply the patches to >>> get it to work? Or do I need to get invest in a new wlan card? >>> maybe one of those wpc11's from Linksys? >>> >>> Thanks >>> Nick >>> >>> _______________________________________________ >>> Bat mailing list >>> [email protected] >>> http://lists.dachb0den.com/mailman/listinfo/bat >> >> >> >> >> >> _______________________________________________ >> Bat mailing list >> [email protected] >> http://lists.dachb0den.com/mailman/listinfo/bat > > > _______________________________________________ > Bat mailing list > [email protected] > http://lists.dachb0den.com/mailman/listinfo/bat