Re: [CUWiN] Good Wireless card for nodes?
David Young <[email protected]>
| Newsgroups | gmane.network.wireless.cu-wireless |
|---|---|
| Message-ID | <[email protected]> |
On Wed, Aug 18, 2004 at 08:07:48PM -0500, Shankar Rao wrote: > I have another question. Since I will be using old computers instead of > those soekris boards, I'm assuming that I will need coaxial cable to > get from the antennae to the computer. Do I need any specially > shielded, or will the kind I use to get cable to my room be fine? For 2.4GHz, the quality of the coax cable and the type of connectors are both different from cable TV. You can buy radio jumpers at some of the places mentioned on the list. Shorter jumpers are best. You will need an RP-SMA connector on the radio end of the jumper. The other end depends on your antenna, but it is usually an N male connector. Dave -- David Young OJC Technologies [email protected] Urbana, IL * (217) 278-3933 _______________________________________________ CU-Wireless mailing list [email protected] http://lists.cu.groogroo.com/cgi-bin/listinfo/cu-wireless Project Page: http://cuwireless.ucimc.org