[CUWiN] Routeviz and the web interface seem broken

I am running a test with 2 nodes. Default firmware loads in both.
I can ping across the two nodes, but routeviz on each node only shows the
local
node. Also, when I use the reconfigure to change the ssid, nodename etc, the
saved
result does not take effect immediately without a reboot, I can understand
how that might be
true, however after reboot, the ssid fields in the config files are blank
and the radio cards do not come up.

Should I just wait for the .5 release and stop messing with .4?


_______________________________________________
CU-Wireless mailing list
[email protected]
http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
Project Page: http://cuwireless.ucimc.org