Re: [CUWiN] Routeviz and the web interface seem broken

Hi Bob,

You may wish to join the CUWiN Developers list:

http://lists.cuwireless.net/cgi-bin/listinfo/cu-wireless-dev

Where you can get answers and help us test.  Definitely don't spend much 
time with 0.5.4 -- it's old and doesn't have routeviz up and running (thus 
the problems you're having).

--Sascha

On Fri, 4 Feb 2005, Bob Ney wrote:

> I am running a test with 2 nodes. Default firmware loads in both. I can 
> ping across the two nodes, but routeviz on each node only shows the 
> local node. Also, when I use the reconfigure to change the ssid, 
> nodename etc, the saved result does not take effect immediately without 
> a reboot, I can understand how that might be true, however after reboot, 
> the ssid fields in the config files are blank and the radio cards do not 
> come up.
>
> Should I just wait for the .5 release and stop messing with .4?
>
>
> _______________________________________________
> CU-Wireless mailing list
> [email protected]
> http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
> Project Page: http://cuwireless.ucimc.org
>

-- 
Sascha Meinrath
President                 *   Project Coordinator   *   Policy Analyst
Acorn Worker Collective  ***  CU Wireless Network  ***  Free Press
www.acorncollective.com   *   www.cuwireless.net    *   www.freepress.net


_______________________________________________
CU-Wireless mailing list
[email protected]
http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
Project Page: http://cuwireless.ucimc.org