RE: [CUWiN] Antenna

On Tue, 8 Mar 2005, Bob Ney wrote:

> Typically an omni is best used in a mesh environment, Unless you are a 
> large distance away or on the edge of the mesh and need to focus a beam 
> into the existing mesh to pick up a signal.

There's lots of information on our CUWiN Documentation page:

www.cuwireless.net/documentation

Here's a direct link to the relevant section:

http://www.cuwireless.net/documentation/rugged.html#hardware_rugged_ant

--Sascha

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Pasquale
> Falconio
> Sent: Tuesday, March 08, 2005 7:38 AM
> To: [email protected]
> Subject: [CUWiN] Antenna
>
>
> Hi everybody.
>
> Please,
>
> can anybody say to me which kind of antenna is used for the installation of
> a node?
>
> Thank you
>
> _______________________________________________
> CU-Wireless mailing list
> [email protected]
> http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
> Project Page: http://cuwireless.ucimc.org
>
>
>
> _______________________________________________
> CU-Wireless mailing list
> [email protected]
> http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
> Project Page: http://cuwireless.ucimc.org
>

-- 
Sascha Meinrath
President                 *   Project Coordinator   *   Policy Analyst
Acorn Worker Collective  ***  CU Wireless Network  ***  Free Press
www.acorncollective.com   *   www.cuwireless.net    *   www.freepress.net


_______________________________________________
CU-Wireless mailing list
[email protected]
http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
Project Page: http://cuwireless.ucimc.org