[CUWiN] CUWiN using a PC Engines WRAP box

I am attempting to put a CUWiN node up with a WRAP box that I just bought. I copied the 128 mb disk image to the 
flash card ("dd if=imagefile.img of=/dev/disk4 bs=8k") and booted it up. And nothing. I don't have a serial console 
connection so I can't tell if any interesting messages are appearing. I can't connect to it via SSH or and it's not taking 
a DHCP addr.

Now that I go back and read mailing lists etc. I can't find any posts that mention that CUWiN works with the WRAP 
board (only questions; I could have sworn that there was an affirmative somewhere..). So, does it work? Or is my 
system not going to work because CUWiN doesn't run on the WRAP? Or is my problem something else entirely?

I'm in the Urbana area if I could meet up with someone to get this thing working if that would be of use.
Thanks,
Seth

_______________________________________________
CU-Wireless mailing list
[email protected]
http://lists.chambana.net/cgi-bin/listinfo/cu-wireless
Project Page: http://cuwireless.ucimc.org

begin:vcard
n:Price;Seth
fn:Seth Price
tel;home:(608) 260-2687
url:http://www.pricepages.org/
adr:;;1218 Spring St. Apt. 14;Madison;WI;53715;USA
version:2.1
email;internet:[email protected]
end:vcard