Re: wireless->wired aps
"Tyler van Houwelingen" <[email protected]>
| Newsgroups | gmane.network.wireless.seattle.general |
|---|---|
| Message-ID | <002801c5871a$fd5235d0$2201a8c0@Azul> |
speaking of gaming, we have been playing around with the PSPs on our city-wide network in Rio Rancho and it is very cool. WiFi PSP online gaming everywhere you go. Oh if I was a kid again. They dont hand off very well at high speeds, so online gaming while driving requires an on-board mesh repeater. tyler Tyler van Houwelingen Founder and CEO Azulstar Networks, Inc. 1051 Jackson, Grand Haven, MI 49417 1117 Rio Rancho Blvd 13, Rio Rancho, NM 87124 1-877-AZULSTAR www.azulstar.com ----- Original Message ----- From: "josh sauer" <[email protected]> To: <[email protected]>; "SeattleWireless Talk List" <[email protected]> Sent: Tuesday, July 12, 2005 1:42 PM Subject: Re: wireless->wired aps You could also use the Linksys Game adapters that are primarily for X-Box and PS2 systems. They're a little spendy, but they work fairly well for connecting legacy pc's to a wireless network, if you have ethernet available on the machines. On 6/1/05, Bryan Irvine <[email protected]> wrote: > I found it. The Linksys WETxx line is what I'm looking for. > > thanks! > > --Bryan > > On 5/26/05, Devin McBride <[email protected]> wrote: > > My understanding is a linksys wrt54g with a sveasoft firmware will do > > this...router acts as a wireless bridge and I believe the ethernet ports > > will allow you to connect the wired computers. Someone correct me > > please if this is incorrect. > > > > Devin > > > > -----Original Message----- > > From: [email protected] > > [mailto:[email protected]] On Behalf Of Bryan Irvine > > Sent: Thursday, May 26, 2005 3:23 PM > > To: SeattleWireless Talk List > > Subject: wireless->wired aps > > > > I have some systems in my garage that cannot be plugged into my home > > network via either the wired or wireless network. They can't reach > > the switch in my living room connected to my living room, nor are they > > new enough to accept aireless cards. What would someone suggest using > > as some sort of cheap bridge that would convert the signal back to > > wired for those systems? > > > > I might have soimething to trade if someone has one they aren't using. > > > > --Bryan > > _______________________________________________ > > Talk mailing list > > [email protected] > > http://seattlewireless.net/mailman/listinfo/talk > > > _______________________________________________ > Talk mailing list > [email protected] > http://seattlewireless.net/mailman/listinfo/talk > _______________________________________________ Talk mailing list [email protected] http://seattlewireless.net/mailman/listinfo/talk _______________________________________________ Talk mailing list [email protected] http://seattlewireless.net/mailman/listinfo/talk