Re: metrix and Soekris questions

I have also used the NYCwireless pebble on a 4501 with no issues.

On 1/9/06, Ken <[email protected]> wrote:
>
>
> On 1/9/06, Gary <[email protected]> wrote:
> > The recent questions about m0n0wall prompted me to post this since I
> > couldn't get m0n0 to bridge my WLAN and LAN interfaces (Soekris 4501
> > board with a Senao prism 2.5 based mini-PCI card). In fact, the only
> > small OS I've had any luck with was OpenBSD 3.7 (last summer prior to
> > 3.8's release). FYI, I used a kernel from flashboot
> > (http://www.mindrot.org/flashboot.html) and an install
> script from
> > flashdist ( http://www.nmedia.net/~chris/soekris/). I
> might try nanoBSD
> > next since it appears to be a variant of picoBSD rolled in to the
> > official FreeBSD release.
> >
> > Anyhow, I've just successfully installed the aging pebble linux on a
> > 128mb CF card. I've been reading through the metrix pebble release notes
> > and although it says its optimized for newer PCMCIA based Soekris
> > boards, it's alleged to work ok on the 4501. Before I spend a lot of
> > time with this, does anyone have it running on a 4501 and, if so, are
> > there any caveats?
>
> I have run it on a 4501 without any problems. This was using a prism2 based
> pci wireless card. I think 4501 was one of the boxes it was intially tested
> on when pebble was created. Are you using the pebble from metrix or from the
> nycwireless.net site?
>
> -Ken
>
> > Much thanks,
> > Gary
> > _______________________________________________
> > Talk mailing list
> > [email protected]
> > http://seattlewireless.net/mailman/listinfo/talk
> >
>
>
>
> --
> Ken Caruso
> [email protected]
> _______________________________________________
> Talk mailing list
> [email protected]
> http://seattlewireless.net/mailman/listinfo/talk
>
>
>
_______________________________________________
Talk mailing list
[email protected]
http://seattlewireless.net/mailman/listinfo/talk