Re: WRT54G: make the switch work as a hub?
| Newsgroups | gmane.network.wireless.seattle.general |
|---|---|
| Message-ID | <[email protected]> |
You need a version of firmware that permits management of 802.1d Spanning Tree Protocol parameters. In Sveasoft's version this is done at the CLI with the "brctl stp" command (sorry, I don't know the exact syntax). On Thursday, June 08, 2006, at 09:57AM, Wiera Lwowna <[email protected]> wrote: >Hi, > >I have WRT54G v.5 and I'm wondering if I can make the switch in >this device work as a hub. Any advice? > > >Thanks, >Presario > >---------------------------------------------------- >Przeprowiednia jest jasna. Znaki s? wyra?ne. >6 dnia, 6 miesi?ca w roku 2006 jego dzie? nadejdzie - Omen. >http://klik.wp.pl/?adr=http%3A%2F%2Fadv.reklama.wp.pl%2Fas%2Fomen.html&sid=788 > > >_______________________________________________ >Talk mailing list >[email protected] >http://seattlewireless.net/mailman/listinfo/talk > > _______________________________________________ Talk mailing list [email protected] http://seattlewireless.net/mailman/listinfo/talk