Re: WRT54G: make the switch work as a hub?

Wiera Lwowna <[email protected]> Sat, 10 Jun 2006 11:09:22 +0200

Newsgroups	gmane.network.wireless.seattle.general
Message-ID	<[email protected]>

> You need a version of firmware that permits management
> of 802.1d Spanning Tree Protocol parameters. In Sveasoft's
> version this is done at the CLI with the "brctl stp"
> command (sorry, I don't know the exact syntax).

Thanks for this info.  However, it doesn't do the trick.  I installed 
DD-WRT micor v23 on my WRT54G v5 and it doesn't work.

Any ideas?


Thanks,
Presario

_______________________________________________
Talk mailing list
[email protected]
http://seattlewireless.net/mailman/listinfo/talk