RE: Weatherproofing a laptop
"James Henry" <[email protected]>
| Newsgroups | gmane.network.wireless.seattle.general |
|---|---|
| Message-ID | <[email protected]> |
It all depends on the local climate. We have some switches installed on the roofs of several casinos and other tall building in Atlantic City to provide fiber based T-1 backhaul for a major cellular carrier. We first used good, enameled, ventilated enclosures. The enclosures were pretty rusted up inside and out in just a year, the RJ-45 ports where we handed off copper Ts to the cell carrier switch were pitted and corroded, and cooling fans in the units seemed to only last 6 months. We pulled them out and replaced them with hermetically sealed air conditioned enclosures. In 3 years we've had just 2 failures (out of about 15 units) and these units were ones that spent their first year or part of it in the un-sealed vented enclosures. That compares to about 6 failures in the first year using ventilated enclosures. The new air conditioned enclosures cost us $2400 each vs. $600 for the old ones, but considering the cost of truck rolls (and the switches at $3500 each) along with the rock solid reliability we gained, it was a no brainer and well worth it. So if your install is near the ocean, even 20 stories above it, consider sealed air conditioned enclosures. Jim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Harmon Seaver Sent: Wednesday, July 05, 2006 8:43 PM To: SeattleWireless Talk List Subject: Re: Weatherproofing a laptop On 7/5/06, JBilderback <[email protected]> wrote: > > > >>Probably the best bet is to put it into a completely sealed box and then put > >>a sun shade over it. > > > > > > I wouldn't put it in a completely sealed box, that would cook it. > > Put it in a little shelter like they use for weather instruments. They > > have a roof with a large enough overhang all around to shade it and > > then the walls are vented -- white-painted wood slats at an angle so > > rain can't get in but air flows freely. Cheap and easy to build or > > you can buy them. Like these: > > > > http://www.rickly.com/MI/InstrumentShelter.htm > > > > But I would put more overhang on the roof. > > > > > > I'd be worried about humidity/moisture if you do this. It seems > likely you'd get condensation on the machine.... and if made it as > far as the motherboard or even connectors, problems would soon follow. That doesn't seem to happen to the electronic weather instrument stuff. Don't know why you'd get any serious condensation anyway, the laptop would be the same temp or a bit higher as the air, condensation would only occur if it was lower temp than the air. -- Harmon Seaver _______________________________________________ Talk mailing list [email protected] http://seattlewireless.net/mailman/listinfo/talk -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.1.394 / Virus Database: 268.9.9/382 - Release Date: 7/4/2006 -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.394 / Virus Database: 268.9.9/382 - Release Date: 7/4/2006 _______________________________________________ Talk mailing list [email protected] http://seattlewireless.net/mailman/listinfo/talk