Re: Fwd: [Orinoco-users] Monitor Mode with Agere Firmware 7.xx and 8.xx
Matt Westervelt <[email protected]> Wed, 25 Apr 2007 18:10:04 -0700
| Newsgroups | gmane.network.wireless.seattle.general |
|---|---|
| Message-ID | <[email protected]> |
Ubiquiti SRC is pretty cool. Atheros (madwifi-ng), 300mw on b/g, 100mw on 802.11a. We just put em on sale too. http://metrix.net/ubiquiti-networks-src-p-4.html -matt Eric Pretorious wrote: > FWIW: The YDI Diamond is just a re-branded Orinoco Classic Silver. I checked the manufacturer's web site (http://www.ydi.com == http://www.proxim.com) and, apparently, the most current release of the firmware is version 8.72. I suppose that I should just start looking for a non-Orinoco PCMCIA card with external antenna connector. > > Thoughts? Recommendations? > > Eric Pretorious > Sunnyvale, CA > > Eric Pretorious <[email protected]> wrote: I just discovered that my YDI Diamond PCMCIA card doesn't work with version 0.15 of the Orinoco code - Firmware versions 7.XX and 8.XX are not supported by the Orinoco code. (It worked just fine with *patched* versions of the earlier code, though.) > > Thoughts? Suggestions? > > Eric Pretorious > Sunnyvale, CA > > Eric Pretorious <[email protected]> wrote: Date: Fri, 20 Apr 2007 18:48:07 -0700 (PDT) > From: Eric Pretorious <[email protected]> > To: [email protected] > Subject: [Orinoco-users] Monitor Mode with Agere Firmware 7.xx and 8.xx > > A long time ago I used to use my YDI Diamond card... > >> [epretorious@localhost ~]$ /sbin/pccardctl ident >> Socket 0: >> product info: "Lucent Technologies", "WaveLAN/IEEE", "Version 01.01", "" >> manfid: 0x0156, 0x0002 >> function: 6 (network) > > ...with Kismet. I applied the Orinoco Monitor Mode Patch to the Orinoco sources, compiled, and - Viola! - everything worked. But now that the Orinoco Driver includes the patch, I can't use my YDI Diamond card. > >> Changes compared with the latest stable release (0.13e): >> >> * Monitor mode support (except Agere firmware 7.xx and 8.xx). > > I had to use three different distro's (Mandriva 2007, Ubuntu 6.10, and *finally* BackTrack2) before I discovered the root cause: > >> [epretorious@localhost ~]$ dmesg | tail -20 >> pcmcia: registering new device pcmcia0.0 >> orinoco 0.15 (David Gibson <[email protected]>, Pavel Roskin <[email protected]>, et al) >> orinoco_cs 0.15 (David Gibson <[email protected]>, Pavel Roskin <[email protected]>, et al) >> eth2: Hardware identity 0001:0001:0004:0002 >> eth2: Station identity 001f:0001:0008:0034 >> eth2: Firmware determined as Lucent/Agere 8.52 >> eth2: Ad-hoc demo mode supported >> eth2: IEEE standard IBSS ad-hoc mode supported >> eth2: WEP supported, 104-bit key >> eth2: MAC address 00:02:2D:B5:8A:E0 >> eth2: Station name "HERMES I" >> eth2: ready >> eth2: orinoco_cs at 0.0, irq 3, io 0x5100-0x513f >> eth2: Monitor mode support is buggy in this firmware, not enabling >> ADDRCONF(NETDEV_UP): eth2: link is not ready >> eth2: New link status: Connected (0001) >> ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready >> eth2: Monitor mode support is buggy in this firmware, not enabling >> eth2: no IPv6 routers present >> eth2: Monitor mode support is buggy in this firmware, not enabling > > (Neither of the other two distro's reported the card's firmware. Why?) > > How can I get back to mapping networks? > > 1. I can compile from source (if I REALLY have to) - Is there some way to revert to the old patch? i.e., The one that supported my YDI Diamond card? > 2. I could just buy a different card with the newer firmware - Is there a list of Orinoco cards that have the newer firmware? > 3. I could just buy a different card with a different chipset - Is there a list of PCMCIA cards with external antenna connectors that support monitor mode? > > Eric Pretorious > Sunnyvale, CA > > > --------------------------------- > Ahhh...imagining that irresistible "new car" smell? > Check out new cars at Yahoo! Autos. ------------------------------------------------------------------------- > This SF.net email is sponsored by DB2 Express > Download DB2 Express C - the FREE version of DB2 express and take > control of your XML. No limits. Just data. Click to get it now. > http://sourceforge.net/powerbar/db2/_______________________________________________ > Orinoco-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/orinoco-users > _______________________________________________ > Talk mailing list > [email protected] > http://seattlewireless.net/mailman/listinfo/talk > > > > --------------------------------- > Ahhh...imagining that irresistible "new car" smell? > Check outnew cars at Yahoo! Autos. > > > ------------------------------------------------------------------------ > > _______________________________________________ > Talk mailing list > [email protected] > http://seattlewireless.net/mailman/listinfo/talk _______________________________________________ Talk mailing list [email protected] http://seattlewireless.net/mailman/listinfo/talk