Re: Choosing services without using bind

>one block of source IP addresses will get this service,
>another will get that service. Can this be done?

Sort of. You will have to create a service entry for each
ip-address. Each one will require the "id" attribute t be
set. It must be different - telnet1, telnet2, telnet3, etc.
You will also have to set the bind attribute to 1 address
each.

I should take a look at the examples, the ones you put in
the e-mails message just look bad. REUSE is on by default,
so its not needed and USERID will slow eveything down and
is untrustworthy unless you control all machines that
access the server. One example should use it but not all of
them.

Hope this helps....
-Steve Grubb

__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com