[zebra 22834] OSPF address family
"joseph halpin" <[email protected]>
| Newsgroups | gmane.network.zebra |
|---|---|
| Message-ID | <[email protected]> |
Hello All, I'm trying to develop a wireless router. I have a soekris net4511 platform running pebble linux and thus zebra ver0.92a. This distro is running with ipv4 only. I have my interfaces established but zebra will not run ospfd. The problem presents as "zebra cannot create router socket address family not supported by protocol ospfd" I'm trying to establish wlan0 as area 0, a shared network-backbone and eth0 as a local network connection. In zebra if I examine the interface I can read off the following show interface Interface Wlan0 index 4 metric 1 mtu 1500 <UP,BROADCAST,RUNNING,MULTICAST> Does this mean that zebra is trying to run multicast? It was not my intention. If so can I work with this. _______________________________________________ Zebra mailing list [email protected] http://ml.zebra.org/mailman/listinfo/zebra