[zebra 22864] Re: Adding ISIS protocol daemon to Zebra
"Pranjal Kumar Dutta" <[email protected]>
| Newsgroups | gmane.network.zebra |
|---|---|
| Message-ID | <[email protected]> |
Zebra Hacking How To http://www.quagga.net/zhh.html Zebra Hacking Gude http://pilot.org.ua/zebra/zebra-hacking-guide.txt Software Architecture of Zebra http://wiki.cs.uiuc.edu/cs427/Software+Architecture+of+Zebra The best way is to read the source code :-), the typical answer. HTH, Pranjal On 4/25/06, Greg Troxel <[email protected]> wrote: > I need to add another protocol, namely IS-IS (a dynamic link state > routing protocol) to Zebra. > > This requires considerable work. > > Can anyone tell me where I can find information on how to add > another protocol to Zebra? So far I found nothing. > > Did you read all the source code :-) ? Seriously, that's one of the > first steps to adding IS-IS. > > > There is a partial IS-IS implementation in quagga (see > www.quagga.net). It's not yet viewed as suitable for production, but > if you want to work on IS-IS it should be on the short list of places > from which to start. > > -- > Greg Troxel <[email protected]> > _______________________________________________ > Zebra mailing list > [email protected] > http://ml.zebra.org/mailman/listinfo/zebra > _______________________________________________ Zebra mailing list [email protected] http://ml.zebra.org/mailman/listinfo/zebra