[zebra 23114] Re: Unable to start Zebra in UML

Hi

Did you build Quagga in UML again? and make sure that you have all
necessary packages to build UML (Compilers .. etc).

Thanks,
Regards
Balaji



On 2/4/08, [email protected] <[email protected]> wrote:
>
>
>
>
> Hi,
>
>
>
> I loaded quagga into UML file system by running configure with –prefix
> option.
>
> When I boot my UML, the paths for zebra and config files seems fine.
>
> However, when I try to start zebra daemon, it exits with "Floating point
> exception".
>
>
>
> Is anything special needs to be done, if I want to run zebra in UML?
>
>
>
> Thanks.
>
> P Please do not print this email unless it is absolutely necessary. Spread
> environmental awareness.
>
>  The information contained in this electronic message and any attachments to
> this message are intended for the exclusive use of the addressee(s) and may
> contain proprietary, confidential or privileged information. If you are not
> the intended recipient, you should not disseminate, distribute or copy this
> e-mail. Please notify the sender immediately and destroy all copies of this
> message and any attachments.
>
> WARNING: Computer viruses can be transmitted via email. The recipient should
> check this email and any attachments for the presence of viruses. The
> company accepts no liability for any damage caused by any virus transmitted
> by this email.
>
>  www.wipro.com
> _______________________________________________
> Zebra mailing list
> [email protected]
> http://ml.zebra.org/mailman/listinfo/zebra
>
>