[zebra 23198] Re: How to post-configure Zebra on fedora 11

Hi ,

Can we fix this problem by enabling ipforwarding in the Router ?
 --sathya





________________________________
From: "Dierlam, Andy David" <[email protected]>
To: Jimmy H.G. <[email protected]>; [email protected]
Sent: Thursday, 6 August, 2009 3:19:32 AM
Subject: [zebra 23197] Re: How to post-configure Zebra on fedora 11

Do you have the iptables running or anytihng that would block ?

Thanks,
Andy

________________________________

From: [email protected] on behalf of Jimmy H.G.
Sent: Wed 8/5/2009 5:43 PM
To: [email protected]
Subject: [zebra 23196] How to post-configure Zebra on fedora 11


Hiii 

I installed zebra without problems in fedora 11, my fedora11 have two networks interfaces,
eth0 and eth1. Both are configured only with an ip and mask (without gateway), I started quagga with commands:
zebra -d
ripd -d   (rip is configured with version 2)

In each segment of LAN and WAN I have reply (using ping) from ip of router (fedora 11, zebra) but is not routing, I can't connect from WAN to LAN, LAN to WAN, there is no events in zebra.log and ripd.log with errors.
I don't know where is the problem.
Is there same configuration aditional on fedora 11 after of install zebra ??

My network topology is:

PC-WAN -------------eth1 zebra (fedora11) eth0 -------------------- PC-LAN 
172.16.1.10              .1                            192.168.1.1                .10

connection PC-WAN to zebra  ok
connection PC-LAN to zebra  ok
connection PC-WAN to PC-LAN  Fail
connection PC-LAN  to PC-WAN Fail

Thank you

Jimmy

_______________________________________________
Zebra mailing list
[email protected]
http://ml.zebra.org/mailman/listinfo/zebra



      See the Web&#39;s breaking stories, chosen by people like you. Check out Yahoo! Buzz. http://in.buzz.yahoo.com/

_______________________________________________
Zebra mailing list
[email protected]
http://ml.zebra.org/mailman/listinfo/zebra