Re: [siteplan] Heating wash water

I'm probably ready to get back involved. Through out some evening  
dates and let me know what's left to do on site or are we ready to  
make fuel? I haven't been out at the site for several weeks.

On Jan 10, 2007, at 6:28 PM, Felix Kersting wrote:

> Zac and all,
>
> Regarding heating the wash water (about 50 gallons).  I was  
> referring to heating the water that goes in the wash tote, not the  
> 2.5 gallons of prewash.  It would be a snap to heat just a few  
> gallons of water for prewash as long as 1) the top element of the  
> water heater is disconnected and 2) the amount of water you put in  
> the heater is a couple inches above the lower element.  This can be  
> easily gaged - if the water is above the top of the bottom element  
> cover in the sight tube.
>
> Greg R - do you use warm or cold water for washing?
>
> We probably need to meet sometime soon to discuss the next steps of  
> processor reunification.  Would an evening work for everyone?   
> There are some lights on site.
>
> Felix
>
> 503-969-5996
> _______________________________________________
> siteplan mailing list
> [email protected]
> http://lists.gobiodiesel.org/mailman/listinfo/siteplan
>
>

--------------------------------------------------------------
Zac Imboden
[email protected]
1534 SE 35th Place
Portland, OR
97214
971-563-2477