Work done this week

Felix, Greg R, Zack and Karen K. were on site.

We were unsuccessful separating the water out of the oil, so no fuel was 
made before 12:30, when I left.  There is a plan, I expect Zac will 
explain in an email to follow.

Other things that did happen;

The existing compressor came to life.  There were wires disconnected in 
the switch on the compressor and they were repaired.  Does anyone know 
why it was disconnected?  I suspect it was just over looked when Ron set 
up the power from Brian's house.  Does anyone know if the oil has been 
checked or changed in that compressor recently?  This would be a good 
task for someone.

The thermometer was installed in the processor and the element was moved 
to the back j-box.

The plumbing on the wash tank was completed.

At least one element was reinstalled in the second oil heater - all 
tested fine.  Ron - do you know if any elements were bad and which ones 
specifically?

I have a suggestion that will allow us to heat 200 gallons of oil pretty 
much simultaneously - using the power that is already in the Conex.  I 
need the advice/help of an electrician to execute the plan - Zan or Ron 
are you interested? - I can explain by email pretty easily.

Felix