Re: Initilization using Reset signal

Zellal, 
Try to reset all of your module signal at the start of simulations.It
implies setting a value for all signals at the start.
For instance, if ur reset is active low , try to set the reset signal to
zero at the start. run ur simualtion and check the values of the signals
with U output. This should be eliminated.
Thanks 

best Regards,

On Wed, 2004-02-04 at 16:56, Zellal B wrote:
> Good evening,
> 
> i did my module, compile it with no errors with its testbench but it
> seems when i simulate it i had the signal  "U" what does that mean,
> could u please help me with that...thank you
> 
> 
> 
> ______________________________________________________________________
> Help STOP spam with the new MSN 8  and get 2 months FREE*
> ---------------------------------- General Handasa Arabia Mailinglist
> http://www.handasarabia.org [email protected] for
> help Message number 79
-- 
Mohamed A.Salem
Handasa Arabia Co-Founder
www.handasarabia.org



----------------------------------
General Handasa Arabia Mailinglist
http://www.handasarabia.org
[email protected] for help

Message number 80