Re: Re: [bluetooth] LMP and Software interface

Mike Rowehl <[email protected]> Mon, 16 Jun 2003 00:41:03 -0700

Newsgroups	gmane.org.handasarabia.nour
Message-ID	<[email protected]>

On  0, Jamil Khatib <[email protected]> wrote:
> 
> Hi,
> Please try to look at figure 1 in the bluetoooth design document. This figure
> shows the hardware moduels block diagram.
> WB bus connects between the cores on the module only. the module is connected
> to the host using either UART or USB where HCI and higher level protocols run
> on the host.

Yes, I see.  Thank you for taking the time to answer my questions.

--- 8< -- 8< ---
> So what I am focusing now is the firmware located on the module that includes
> the baseband driver, LMP, USB/UART drivers and HCI part on teh miodule.
> 
> If you know anyone who can help us please invite him.
> 
Unfortunately I do not know anyone with this base of experience.  I have an
idea which may help us to prove out the register design and get a start on the
firmware.  I will start another thread on the list.  Once again, thank you for
your clarifications.
                                                       Mike

---------------------------------------------------------------------
To unsubscribe, e-mail: nour-unsubscribe-bZJqt4gKw0dwc45b+y0WwMLKnirKmNT7@public.gmane.org
For additional commands, e-mail: [email protected]
Handasa Arabia, http://www.handasarabia.org