Linux and 3D printing

--e89a8f234d2b56425c04d2ddfa57
Content-Type: text/plain; charset=ISO-8859-1

Hey, I'm here too....

...and I have a question.

Is anyone on the list a 3d printer guru?

I've finally taken the plunge and am assembling a printer (a Mendelmax
1.5), and would like to chat with someone about the software end of things.
Ideally, I would like to be able to keep my entire "tool chain" based in
Linux, and wondered if anyone could help point me in the right direction.

Regards -

Richard Perry

--e89a8f234d2b56425c04d2ddfa57
Content-Type: text/html; charset=ISO-8859-1
Content-Transfer-Encoding: quoted-printable

<div dir=3D"ltr">Hey, I&#39;m here too....</div>
<div dir=3D"ltr">=A0</div>
<div dir=3D"ltr">...and I have a question.</div>
<div dir=3D"ltr">=A0</div>
<div dir=3D"ltr">Is anyone on the list a 3d printer guru?</div>
<div dir=3D"ltr">=A0</div>
<div dir=3D"ltr">I&#39;ve finally taken the plunge and am assembling a prin=
ter (a Mendelmax 1.5), and would like to chat with someone about the softwa=
re end of things. Ideally, I would like to be able to keep my entire &quot;=
tool chain&quot; based in Linux, and wondered if anyone could help point me=
 in the right direction.</div>

<div dir=3D"ltr">=A0</div>
<div dir=3D"ltr">Regards -</div>
<div dir=3D"ltr">=A0</div>
<div dir=3D"ltr">Richard Perry</div>
<div dir=3D"ltr">=A0</div>

--e89a8f234d2b56425c04d2ddfa57--