Re: Problem Booting Kernel 2.6.0

Seems all it took was to remove the lba32 option and it worked.

I think, to save myself a headache down the road, I'll go ahead and
switch over to the method the site you referenced lays things out for a
dual boot system.

Thank you very much for your help!


-----Original Message-----
From: [email protected] [mailto:[email protected]]
On Behalf Of Jeff Vian
Sent: Wednesday, November 12, 2003 2:38 PM
To: [email protected]
Subject: [linux-help] Re: Problem Booting Kernel 2.6.0

I reviewed the page I referenced in my earlier reply 
http://www.geocities.com/epark/linux/grub-w2k-HOWTO.html and I noted it 
says that with multiple drives the /boot partition must be on the same 
hard drive that has the boot loader.  In my experience this is not a 
requirement, and in fact none of mine have ever been set up that way.

The warning from LILO is likely the key, combined with the NTLDR 
limitations.

Justin Hamm wrote:

>Hello,
>
>I have come across a problem (others might have had similar probs) in
>relation to kernel 2.6.0. I'm running LILO 22.5.8 with Debian unstable
>with security updates, kernel 2.6.0test6. 
>
>I have a problem booting to 2.6.0, here is the error I receive:
>
>-- snip --
>VFS: Cannot open root device "1602" or unknown-block(22,2)
>Please append a correct "root=" boot option
>Kernel panic: VFS: Unable to mount root fs on unknown-block(22,2)
>-- snip --
>
>Here is my lilo.conf file:
>
>-- snip --
>lba32
>boot=/dev/had
>root=/dev/hdc2
>install=/boot/boot-menu.b
>map=/boot/map
>delay=20
>prompt
>timeout=150
>vga=normal
>default=Linux
>
>image=/vmlinuz
>	label=Linux
>	read-only
>
>image=/vmlinuz.old
>	label=LinuxOLD
>	read-only
>	optional
>
>other=/dev/hda1
>	label="WinXP(hda1)"
>-- snip --
>
>I have gone in and tried other suggestions from other lists.. such as
>adding a line append="root=/dev/hdc2" which had no effect, Also tried
>running root=1602 just for giggles but it also had no effect (as I
>didn't think it would.. but I ran outta options).
>
>Has anyone else experienced this problem when switching to 2.6.0?
>
>If anyone needs additional information, I'll be happy to provide it.
>
>Also, After I run /sbin/lilo to update any changes made, it keeps
giving
>me: "Warning: The boot sector and map file are on different disks."
>Which I'm pretty sure I understand as a harmless warning, most dualboot
>systems could result in the same if lilo wasn't installed on the Linux
>partition... So I guess ignore that..
>
>Thank you!
>Justin
>
>
>-- This is the [email protected] list.  To unsubscribe,
>visit http://www.complete.org/cgi-bin/listargate-aclug.cgi
>
>
>  
>

-- This is the [email protected] list.  To unsubscribe,
visit http://www.complete.org/cgi-bin/listargate-aclug.cgi



-- This is the [email protected] list.  To unsubscribe,
visit http://www.complete.org/cgi-bin/listargate-aclug.cgi