Re: Debian Problem with mouse

What device does your XF86Config-4 file point to for the mouse?  Should
probably be /dev/ttyS0 for a serial mouse, possibly /dev/ttyS1 (S2 and S3
are also possibilities, but pretty unlikely on a semi-modern computer).

If you absolutely cannot get it to work, you may have better luck using gpm
and a repeating protocol.  In that scenario, you'll tell gpm to use
/dev/ttyS0 (or similar), then tell it to repeat.  Then X will use
/dev/gpmdata.  (What this does is GPM runs the mouse driver, then 'repeats'
all the mouse events to the /dev/gpmdata for X to receive as well).  In some
cases this can be the best setup anyway (particularly with oddball mice that
X doesn't like very well, but gpm works fine with).

-- Jonathan


----- Original Message -----
From: "bbales" <[email protected]>
To: <[email protected]>
Sent: Wednesday, June 08, 2005 7:11 PM
Subject: [linux-help] Debian Problem with mouse


> I finally broke down and bought the seven Debian CD set.  Received it the
> day they released 3.1.  Installed a minimal system on an old 200MHz box.
> KDE comes up fine, but the mouse won't move.  XF86Config-4 has two
> sections for mouse, both appear to be for a wheel mouse.  I tried to edit
> XF86Config directly (as I have done often with Red-Hat) and it somehow
> completely hosed the system.  So I have reloaded the system and the mouse
> is again inoperable.  The mouse is a serial, three-button which still
> works on this box with windows.
>
> Does Debian have a secret configuration tool for XF86Config?  Or could
> there be some other problem with the mouse?
> bruce
>
>
>
> -- This is the [email protected] list.  To unsubscribe,
> visit http://www.complete.org/cgi-bin/listargate-aclug.cgi
>
>


-- This is the [email protected] list.  To unsubscribe,
visit http://www.complete.org/cgi-bin/listargate-aclug.cgi