Re: FW: Errors on The Aclug Community

> -----Original Message-----
> From: [email protected] [mailto:[email protected]]On Behalf
> Of Tom Hull

> >
> > I'm trying to run OpenACS on Debian. Things were working fine
> until I updated
> > the database to version 7.2.1.  Enclosed is the message from the OpenACS
> > logwatch daemon:
>
> Yecch! I don't have a good answer at this point, and may not unless I load
> 7.2.1 myself. (I'm running 7.1.2 at home; 7.1.3 on the website.) The notes
> below are just some thoughts on debugging the problem. Good luck.
>
> The 7.2 doc says that you shouldn't have to dump and reload the database.
> But you might do another createdb and reload the schema, just to see if
> an error pops up elsewhere. I haven't found a detailed 7.1 -> 7.2 release
> note.

I've gone as far as to completely remove and then re-install both the
database and OpenACS. At first I thought it was a configuration error on my
part, as I hadn't read completely through the log files.  All I knew at the
time was that it was refusing to serve pages.  Only after spending a lot of
time and getting nowhere did I think to tail the log files and realized the
database was erroring out.  The OpenACS website has so far been of little
help.

--dwh

---
Dale W Hodge - [email protected]
Vice Chairman & Secretary - [email protected]
Air Capital Linux User's Group  (ACLUG)
---