Re: router DIY

Ben Francis <[email protected]>
Newsgroups gmane.org.user-groups.linux.svlug
Message-ID <CAKmOqmThcwb+O1oda9tjY6EMwWAPiEZ-8eFR5NBfNZ-_hVbrGw@mail.gmail.com>
> My use case would be a 1Gbits downstream/200Mbits upstream connection
for *home* use where most of the times there will be just 1 concurrent
wired user and possibly 2 active wireless users.

I used to think that, too, until one day I check my DCHP leases and found
no less than 13 connected devices, and they were all legitimate (lots of
tablets in the household).

> A netgear R6250 still seems a more reasonable solution unless I've a
chance to put my hands on something cheaper.

The reviews might give you pause:
https://www.amazon.com/NETGEAR-AC1600-Wi-Fi-Gigabit-Router/product-reviews/B00BR3ZYIW/ref=cm_cr_dp_d_hist_1?ie=UTF8&filterByStar=one_star&reviewerType=avp_only_reviews

If you can do without the wired link, a Raspberry Pi could do the wireless
routing for $35:

https://jacobsalmela.com/2014/05/19/raspberry-pi-and-routing-turning-a-pi-into-a-router/

Ben

On Thu, Feb 9, 2017 at 5:40 AM, Ivan Sergio Borgonovo <[email protected]>
wrote:

> On 02/08/2017 11:10 PM, Ben Francis wrote:
> > He said it was Baytrail Celeron J1900 small form factor PC at 33:32
> >  of the video and he shows it to the camera.
>
> Sorry, audio sucked a bit and I'm not mother-tongue english.
> Actually, talk didn't seem too technical so I fast forwarded a lot.
>
> > https://www.amazon.com/Barebone-Qotom-Q190G4N-S07-
> Celeron-Processor-firewall/dp/B01N645UJB/ref=sr_1_4?ie=UTF8&
> qid=1486591436&sr=8-4&keywords=qotom
> > <https://www.amazon.com/Barebone-Qotom-Q190G4N-S07-
> Celeron-Processor-firewall/dp/B01N645UJB/ref=sr_1_4?ie=UTF8&
> qid=1486591436&sr=8-4&keywords=qotom>
>
> I noticed this hardware too. But including shipping they are way too
> expensive and I'll have to add an access point.
>
> Still it is nice to see it can handle nearly as much traffic as a direct
> connection.
> I haven't had time to listen what was the actual iptables setup for the
> benchmark. If he was just moving stuff from one interface to the other
> or if he was doing NAT.
>
> My use case would be a 1Gbits downstream/200Mbits upstream connection
> for *home* use where most of the times there will be just 1 concurrent
> wired user and possibly 2 active wireless users.
>
> A netgear R6250 still seems a more reasonable solution unless I've a
> chance to put my hands on something cheaper.
>
> I can't still understand the price segmentation of the market.
>
> --
> Ivan Sergio Borgonovo
> http://www.webthatworks.it http://www.borgonovo.net
>
>
> _______________________________________________
> svlug mailing list
> [email protected]
> http://lists.svlug.org/lists/listinfo/svlug
>

_______________________________________________
svlug mailing list
[email protected]
http://lists.svlug.org/lists/listinfo/svlug
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.