: Toshiba Laptop Overheating
[email protected] Mon, 11 Aug 2014 17:22:01 -0400
| Newsgroups | gmane.org.user-groups.linux.tolug |
|---|---|
| Message-ID | <[email protected]> |
I have two Toshiba laptops here. The Satellite PA3373U-1MPC (doesn't that just roll off your tongue?) has two large fan openings in the bottom, each of which is accompanied by a fan. There is also a warning 'Hot base may cause burn. Avoid prolonged contact with bare skin.' (If it's too hot for comfort, why would you prolong the agony?) This machine runs reliably only if it's on top of a fan-cooling base. Kind of defeats the purpose of being portable. The second machine, a Satellite L500D, has only one fan opening and no hot spot warnings, but the exhaust from the fan is quite hot. I installed Linux Mint on it and the result was very nice. Then the video died, and I see on the internet that it is not uncommon for the internal temperature to rise to the point where the video chip comes unsoldered from the PC board. The solution apparently is to reflow the solder joints. I could do that, but given that the fan is working correctly, why wouldn't it happen again? I'd recommend staying away from Toshiba laptops unless they are known to have fixed this problem. I'm going to scrap these two, if anyone wants them. Peter -- Peter Hiscocks Syscomp Electronic Design Limited, Toronto http://www.syscompdesign.com USB Oscilloscope and Waveform Generator 647-839-0325 -- The Toronto Linux Users Group. Meetings: http://gtalug.org/ TLUG requests: Linux topics, No HTML, wrap text below 80 columns How to UNSUBSCRIBE: http://gtalug.org/wiki/Mailing_lists