[cisco] Re: [newbie]boot# load image

"Sorin CONSTANTINESCU" <[email protected]>
Newsgroups gmane.org.user-groups.rlug.general,gmane.org.user-groups.rlug.cisco
Message-ID <[email protected]>

http://www.cisco.com/en/US/products/hw/switches/ps607/prod_release_note09186a00800d9e0a.html#17313

Upgrading the Software via XMODEM Protocol
The following procedure uses the XMODEM protocol to upgrade the switch
software. This procedure is largely dependent on the terminal-emulation
software you are using.


--------------------------------------------------------------------------------
Note This procedure can take up to 25 minutes to complete.
--------------------------------------------------------------------------------

Step 1 Connect a PC with terminal-emulation software supporting the XMODEM
protocol to the switch console port.

Step 2 Set the line speed on the emulation software to 9600 baud.

Step 3 Unplug the power cord from the back of the switch.

Step 4 Press and hold in the Mode button, and at the same time, reconnect
the power cord to the switch. You can release the Mode button a second or
two after the LED above port 1X goes off. Although the switch software did
not start, you can use the boot loader to enter commands.

Step 5 At the switch: prompt, enter the flash_init command to initialize
the flash file system:

switch: flash_init

Step 6 Enter the copy xmodem boot loader command to start the transfer.

Step 7 switch: copy xmodem: flash:image_filename

Step 8 When the XMODEM request appears, use the appropriate command on the
terminal-emulation software to start the transfer and copy the software
image into Flash memory.



>
>
>
> deci am 2 routere identice cisco 800 series
>
> pe unul dintre ele cand imi booteaza baga intr-un promt boot# spunandumi
> ca nu gaseste un fis
>
> am observat ca atunci cand ii dau list imi apare un singur fisier :
>
> TinyROM-1.4(1)
>
> in timp ce pe celalalt router (care merge perfect) cand intru in promtul
> astacu ctrl-break(in timp ce booteaza imi mai apare un fisier :
>
> c805-y6-mw.122-12a.bin
>
> presupun ca nu primul booteaza pt ca nu are fis asta
>
> deci am salvat de pe al doilea router(cel care merge) flierul
> ala(c805.....) dar nu stiu cum sa il bag pe routerul bulit .cum fac asta
> ?
>
>
>
>
>
>
>
>
> ----------------------------------------------------------------------------
> Protect your PC - Click here[1] for McAfee.com VirusScan Online
>
> --- Links ---
>    1 http://g.msn.com/8HMHEN/2755??PS=


-- 
Sorin CONSTANTINESCU
[email protected]
Linux Registered User #222086
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.