Re: virtual router

ca sa testezi ceva trebuie sa te si intereseze cu adevarat.

BTW: Cine foloseste Juniper in Romania?

/brick.
----- Original Message ----- 
From: "Ciprian Niculescu" <[email protected]>
To: <[email protected]>
Sent: Monday, March 03, 2003 5:07 PM
Subject: [rlug-cisco] Re: virtual router


On Mon, 3 Mar 2003 15:06:22 +0200, "Cristian Caramida"
<[email protected]> said:
> full-table e toata tabela internet: 118K prefixe.

da de unde stii ca nu sunt 117K so e mai putin asa ca intra in memorie
:))))

pai cine te opreste sa testezi la kpn, eu nu am de unde sa i-au
full-table, sau tu nu esti admin in kpn

C

> Intrebarea era daca a incercat cineva sa tina tabela asta in mai multe
> vrf-uri.
> Din ce povestesti tu, cu clienti care folosesc un virtual-router al tau
> exista posibilitatea sa fii nevoit sa faci asa ceva si ma
> intrebam cum merge; cam cata memorie iti trebuie pe RP/LCs.
> 
> ----- Original Message -----
> From: "Ciprian Niculescu" <[email protected]>
> To: <[email protected]>
> Sent: Monday, March 03, 2003 2:45 PM
> Subject: [rlug-cisco] Re: virtual router
> 
> 
> aha, ok, mersi, intrebare ce e full-table :))))
> 
> C
> 
> 
> On Mon, 3 Mar 2003 13:18:20 +0200, "Cristian Caramida"
> <[email protected]> said:
> > desi vrf-u' s-a facut pentru mpls/vpn nu este necesar sa ai mpls ca sa-l
> > folosesti...
> > la cisco configul tau ar fi:
> >
> > ip vrf vr1
> >  rd 1:1
> > !
> > ip vrf vr2
> >  rd 1:2
> > !
> > int fa1/0
> >  ip vrf forwarding vr1
> >  ip add 1.1.1./24
> > !
> > int fas 1/1
> >  ip vrf forwarding vr2
> >  ip add 1.1.1.2/24
> > !
> > int fas 1/2
> >  ip vrf forwarding vr2
> >  ip add 3.3.3.1/24
> > !
> > ip route vrf vr1 0/0 1.1.1.2
> >
> > Ma rog; nu e asa de ordonat ierarhic ca la juniper; da se intelege.
> > La cisco ai un default-table si pe urma virtual routing tables.
> > Pentru a pune route in celelalte tabele exista:
> > ip route vrf .....
> >
> > In general cisco nu recomanda sa ai full-table decat in default-table.
> > A incercat cineva sa tina de mai multe ori full-table in cateva vrf-uri?
> >
> > /brick.
> > ----- Original Message -----
> > From: "Ciprian Niculescu" <[email protected]>
> > To: <[email protected]>
> > Sent: Monday, March 03, 2003 1:08 PM
> > Subject: [rlug-cisco] Re: virtual router
> >
> >
> > :))) pai deasta e ceata mare/groasa ca atunci cand am config mpls am
> > folosit ip vrf ...., dar daca nivelul ip standard nu e ok, mplsul nu o sa
> > imi mearga, adik eu vreau asa:
> > ok sa spun ce pot sa fac cu un Juniper si vreau sa fac si cu un Cisco
> > (daca se poate si cica se poate)
> >
> > Ruter cu 3 interfetze 1/0 1/1 1/2, in 1/2 am un pc cu 3.3.3.3, am un
> > cablu de la 1/0 la 1/1
> >
> > definesc
> >
> > virtual-router vr1
> > int fa 1/0
> >   ip add 1.1.1.1/24
> > ip route 0/0 1.1.1.2
> >
> > virtual-router vr2
> > int fa 1/1
> >   ip add 1.1.1.2/24
> > int fa 1/2
> >   ip add 3.3.3.1/24
> >
> > trace de pe vr1 catre 3.3.3.3 trece prin 1.1.1.2 si apoi 3.3.3.3
> >
> > so ?????
> >
> > logica lui nenea Juniper este ca esti ISP si inchiriezi ruterul tau la un
> > client, dar nu ai chef sa ai 50 de rutere fizice separate ci ai unu
> > singur pe care definesti virtual-router. Se poate sa ai un singur link
> > iar pe el definite mai multe subinterfetze fiecare in vr-uri diferite,
> > binenteles ca linkul tre sa fie atm/fr/fe/ge, adik ceva care stie
> > diferentiere prin ceva (vlan,pvc)
> >
> > C
> >
> > P.S. disclaiment: nu lucrez la o reprezentantza Juniper :))))
> >
> >
> > On Mon, 3 Mar 2003 12:40:15 +0200 (EET), "George Boulescu"
> > <[email protected]> said:
> > >
> > > adica pe limba lu' cipy: MPLS (sau tag-switching)
> > >
> > > > ip vrf forwarding <name> pe interfetele care vrei sa fie in routerul virtual.
> > > > Si poti activa ospf/isis/rip etc in acel vrf (sunt instante/procese) diferite pentru fiecare vrf.
> > > >
> > > > Pe urma show ip vrf; show ip route vrf; show ip cef vrf; etc
> > > > /brick.
> > > > ----- Original Message -----
> > > > From: "Ciprian Niculescu" <[email protected]>
> > > > To: <[email protected]>
> > > > Sent: Monday, March 03, 2003 12:27 PM
> > > > Subject: [rlug-cisco] Re: virtual router
> > > >
> > > >
> > > > ok, am ajuns acolo, dar tot in ceatza sunt, are cineva facut sau sunt
> > > > numai banuieli
> > > >
> > > > C
> > > >
> > > > Cristian Caramida wrote:
> > > > > ip vrf
> > > > > (Virtual Routing & Forwarding)
> > > > >
> > > > > /brick.
> > > > > ----- Original Message -----
> > > > > From: "Ciprian Niculescu" <[email protected]>
> > > > > To: <[email protected]>
> > > > > Sent: Monday, March 03, 2003 12:12 PM
> > > > > Subject: [rlug-cisco] Re: virtual router
> > > > >
> > > > >
> > > > > VRRP gasisem dar este exact invers: din 2 fizice faci unul virtual
> > > > > si HSRP este la fel
> > > > >
> > > > > eu vreau invers am unul fizic si sa il impart in doua virtuale, fiecare
> > > > > cu tabela lui de rutare, acl ....
> > > > >
> > > > > C
> > > > >
> > > > > Vilcu, Stefanita Valeriu wrote:
> > > > >
> > > > >>Cauta si tu dupa VRRP, HSRP.
> > > > >>
> > > > >>Vampi
> > > > >>
> > > > >>
> > > > >>-----Original Message-----
> > > > >>From: [email protected] [mailto:[email protected]]On Behalf Of
> > > > >>Ciprian Niculescu
> > > > >>Sent: Monday, March 03, 2003 11:21 AM
> > > > >>To: [email protected]
> > > > >>Subject: [rlug-cisco] Re: virtual router
> > > > >>
> > > > >>
> > > > >>adik? un link ceva ca nu am gasit nimic
> > > > >>
> > > > >>C
> > > > >>
> > > > >>Vilcu, Stefanita Valeriu wrote:
> > > > >>
> > > > >>
> > > > >>>Din cite stiu eu numai pe GSR.
> > > > >>>
> > > > >>>Vampi
> > > > >>>
> > > > >>>
> > > > >>>-----Original Message-----
> > > > >>>From: [email protected] [mailto:[email protected]]On Behalf Of
> > > > >>>Ciprian Niculescu
> > > > >>>Sent: Monday, March 03, 2003 10:51 AM
> > > > >>>To: [email protected]
> > > > >>>Subject: [rlug-cisco] virtual router
> > > > >>>
> > > > >>>
> > > > >>>routerele Juniper au comanda "virtual-router" care creaza un ruter
> > > > >>>virtual in Cisco exista asa ceva????
> > > > >>>
> > > > >>>
> > > > >>>C
> > > > >>>
> > > > >>>---
> > > > >>>Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > >>>(without quotes) to unsubscribe from this list.
> > > > >>>
> > > > >>>---
> > > > >>>Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > >>>(without quotes) to unsubscribe from this list.
> > > > >>
> > > > >>
> > > > >>
> > > > >>---
> > > > >>Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > >>(without quotes) to unsubscribe from this list.
> > > > >>
> > > > >>---
> > > > >>Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > >>(without quotes) to unsubscribe from this list.
> > > > >
> > > > >
> > > > >
> > > > > ---
> > > > > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > > (without quotes) to unsubscribe from this list.
> > > > >
> > > > >
> > > > >
> > > > >
> > > > > ---
> > > > > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > > (without quotes) to unsubscribe from this list.
> > > >
> > > >
> > > > ---
> > > > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > (without quotes) to unsubscribe from this list.
> > > >
> > > >
> > > >
> > > >
> > > > ---
> > > > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > > (without quotes) to unsubscribe from this list.
> > > >
> > >
> > > --
> > >
> > > George Boulescu
> > > Senior Network Engineer
> > > RoEduNet Bucharest NOC
> > > CCAI, CCNA
> > >
> > > ---
> > > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > > (without quotes) to unsubscribe from this list.
> > >
> > >
> > ---
> > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > (without quotes) to unsubscribe from this list.
> >
> >
> >
> >
> > ---
> > Send e-mail to [email protected] with subject "unsubscribe cisco"
> > (without quotes) to unsubscribe from this list.
> >
> >
> ---
> Send e-mail to [email protected] with subject "unsubscribe cisco"
> (without quotes) to unsubscribe from this list.
> 
> 
> 
> 
> ---
> Send e-mail to [email protected] with subject "unsubscribe cisco" 
> (without quotes) to unsubscribe from this list.
> 
> 
---
Send e-mail to [email protected] with subject "unsubscribe cisco" 
(without quotes) to unsubscribe from this list.




---
Send e-mail to [email protected] with subject "unsubscribe cisco" 
(without quotes) to unsubscribe from this list.