[cisco] Ipx

S-a facut de luni :( asa ca-i dau bice.Le dau drumu in serii scurte,
here it comes:
1. To enable IPX routing , use the #ipx routing in global configuration
mode. The full syntax of the command is
#ipx routing [node]
The argument node indicates the node number of the router. This is a
48-bit value represented by a dotted triplet of four-digit hexadecimal
numbers (xxx.xxxx.xxxx). If you omit node, the router uses the hardware
MAC address currently assigned to it as its node address.
Ce legatura e intre rutare (level3) si node address (sau adresa data
link seriala)care e level2? Ce nevoie am de node?


2.Pentru un router la IPX la configurarea subinterfetei lipseste
specificatia point-to-point|multipoint (sem.3 cap.7.4.2) pe cand la
Frame Relay la configurarea subinterfetei nu lipseste. Care e diferenta
sau ce insemnatate are specificatia?

Multumesc,
Gabriel