[cisco] Re: Ipx

eu zic sa mai citesti
1. frame relay se aplica aplica llayerului 2 si atat
2.IPX este layer 3 el nu are nevoie de multipoint si point tu point
3 descoperirea adreselor de retea la ipx se face cu ajutorul MAC-ului care
se afla in adresa
#ipx routing [node number] -->unde node number este adresa de retea reteaua
respectiva
si acum ce nu intelegi tu sunt reprezentatnte prin


The configuration is very similar to the point-to-point network of Figure
11-9. The biggest
difference is that each point-to-point subinterface is a different IPX
network, as seen in Figure
11-10. Otherwise, SAP and RIP are enabled globally with the ipx routing
command; each is
allowed to be broadcast on interfaces (or subinterfaces) with the ipx
network interface
subcommand. SAP and RIP updates are sent out each subinterface-this means
that Atlanta
will replicate and send three copies of the RIP update and three copies of
the SAP update on its
serial0 interface, one per subinterface, every 60 seconds.
Configuration when using multiple Ethernet encapsulations is the final
configuration option to
be reviewed. In Figure 11-10, assume that Gary is an old NetWare client
running NetWare
version 3.11 client software and using the Ethernet_802.3 Novell
encapsulation. Stephanie is
newer and uses the Ethernet_802.2 encapsulation. Two IPX networks are used
on Nashville's
Ethernet 0 interface in this case.

Asta din Cisco Press CCNA 3.0
daca nu o ai si o vrei da un semn pe personala