[cisco] Re: problema (?!) cu un cisco 2621.

o am si eu pe un ???? 1760 ori 4500, nu mai stiu, dar merg foarte bine
:-)

C

On Tue, 06 Apr 2004 18:23:46 +0300, "George B." <[email protected]>
said:
> Dupa ce i-am pus un 12.2(23) (IP/FW/IDS) la butare, imi da urmatoarea
> kestie:
> System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
> Copyright (c) 1999 by cisco Systems, Inc.
> TAC:Home:SW:IOS:Specials for info
> C2600 platform with 49152 Kbytes of main memory
> 
> program load complete, entry point: 0x80008000, size: 0x587dc8
> Self decompressing the image :
> ###############################################################################################################
> [OK]
> 
> Smart Init is enabled
> smart init is sizing iomem
>   ID            MEMORY_REQ                 TYPE
> 0000A2          0X0010A400 C2600 Dual Fast Ethernet
>                 0X000F3BB0 public buffer pools
>                 0X00211000 public particle pools
> TOTAL:          0X0040EFB0
> 
> If any of the above Memory Requirements are
> "UNKNOWN", you may be using an unsupported
> configuration or there is a software problem and
> system operation may be compromised.
> Rounded IOMEM up to: 5Mb.
> Using 10 percent iomem. [5Mb/48Mb]
> program load complete, entry point: 0x80008000, size: 0x587dc8
> 
> apoi iara self decompressing image, dupa care mai tranteste chestia asta
> odata, si pleaca regulamentar fara probleme (aparent)
> 
> e un c2621 cu 8Mb flash, si 48Mb memorie.
> sa o ignor cu nesimtire sau sa pun doar 12.2(23) IP si atat?
> 
> -- 
> George B. <[email protected]>
> 
> 
>