[cisco] Re: problema (?!) cu un cisco 2621.

Cauta in config o linie de genul:

memory-size iomem 25

Sterge-o.  Softare-ul va dimeniona cum trebuie I/O memory la urmatorul
reboot.  Daca linia reapare in configuratie este OK (depinde de versiunea de
IOS daca apare sau nu in configuratie in mod explicit), este valoarea
corecta si ruterul n-o sa rebooteze.

Este in special important la upgrade-urile de IOS la versiuni diferite (12.1
la 12.2, sa zicem), pentru ca marimea I/O memory necesare difera.

Parerea mea.

Mihai Dumitru

-----Original Message-----
From: [email protected] [mailto:[email protected]]On Behalf Of
George B.
Sent: Tuesday, April 06, 2004 6:41 PM
To: [email protected]
Subject: [cisco] Re: problema (?!) cu un cisco 2621.


ce e mai pikant, ca dupa ce i-am pus ultimu IOS (care il poate suporta
cu memoria si flashu respectiv, adica - c2600-io3-mz.123-6.bin, imi da
eroarea, dar nu mai incarca inca odata imaginea, ci continua
regulamentar si elegant cu boot-up.


On Tue, 2004-04-06 at 18:23, George B. wrote:
> Dupa ce i-am pus un 12.2(23) (IP/FW/IDS) la butare, imi da urmatoarea
> kestie:
> System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
> Copyright (c) 1999 by cisco Systems, Inc.
> TAC:Home:SW:IOS:Specials for info
> C2600 platform with 49152 Kbytes of main memory
>
> program load complete, entry point: 0x80008000, size: 0x587dc8
> Self decompressing the image :
>
############################################################################
################################### [OK]
>
> Smart Init is enabled
> smart init is sizing iomem
>   ID            MEMORY_REQ                 TYPE
> 0000A2          0X0010A400 C2600 Dual Fast Ethernet
>                 0X000F3BB0 public buffer pools
>                 0X00211000 public particle pools
> TOTAL:          0X0040EFB0
>
> If any of the above Memory Requirements are
> "UNKNOWN", you may be using an unsupported
> configuration or there is a software problem and
> system operation may be compromised.
> Rounded IOMEM up to: 5Mb.
> Using 10 percent iomem. [5Mb/48Mb]
> program load complete, entry point: 0x80008000, size: 0x587dc8
>
> apoi iara self decompressing image, dupa care mai tranteste chestia asta
> odata, si pleaca regulamentar fara probleme (aparent)
>
> e un c2621 cu 8Mb flash, si 48Mb memorie.
> sa o ignor cu nesimtire sau sa pun doar 12.2(23) IP si atat?

--
George B. <[email protected]>