[cisco] show running-config pe 1600

salutare,
<beginner here>

am reinitializat un cisco 1600 conform metodei #1 de la
http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_tech_note09186a00802017a1.shtml

am configurat fiecare din cele doua interfete ethernet
am activat ip routing
am creat reguli in firewall pentru a nu putea fi accesat pe ip decat
de la un singur ip dar pentru a raspunde la ping de oriunde
am creat limitari pentru fiecare din adresele ip routate de el (un /29)
am creat un user/parola de nivel 15, l-am configurat astfel incat si
la conectarea pe consola seriala sa ceara user/parola
nu am definit parola de enable

am testat configuratia in birou si se comporta as expected
am plecat cu el la client si l-am montat. aveam link pe ambele
interfete, nu raspundea la ping, nu ruta
l-am resetat, a bootat cam in 2-3 minute si functioneaza
am revenit la birou si m-am conectat pe el sa modific banda unuia din
clienti, dar inainte de conf t am dat un show running-config care nu a
produs nici un output
nu as vrea sa-i dau reload
cum pot sa ies din situatia asta?
outputul de la show version:

core3#show version
Cisco Internetwork Operating System Software
IOS (tm) 1600 Software (C1600-Y-M), Version 12.0(7)T,  RELEASE SOFTWARE (fc2)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Mon 06-Dec-99 19:38 by phanguye
Image text-base: 0x02005000, data-base: 0x0257465C

ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
ROM: 1600 Software (C1600-RBOOT-R), Version 12.0(3)T,  RELEASE SOFTWARE (fc1)

core3 uptime is 1 hour, 46 minutes
System returned to ROM by power-on
System image file is "flash:c1600-y-mz.120-7.T.bin"

cisco 1605 (68360) processor (revision C) with 7680K/512K bytes of memory.
Processor board ID 20361548, with hardware revision 00000003
Bridging software.
X.25 software, Version 3.0.0.
2 Ethernet/IEEE 802.3 interface(s)
System/IO memory with parity disabled
8192K bytes of DRAM onboard
System running from RAM
7K bytes of non-volatile configuration memory.
4096K bytes of processor board PCMCIA flash (Read/Write)

Configuration register is 0x2102

core3#

multumesc,
costin