Re: VOIP QOS setup Q
Ben <[email protected]>
| Newsgroups | gmane.org.user-groups.slug.chat |
|---|---|
| Message-ID | <[email protected]> |
the problem you have is the upstream is only 128. even with QoS, a 1500 byte packet (MTU 1500) will take around 40ms to get through, which means any VoIP packet can suffer up to 40ms delay. Drop the MTU on your router (and probably everywhere else you can) to 576. this will result in slightly more traffic due to the higher overhead, but will reduce the delay. XBox live will refuse to work with an MTU that low, I think everything else is fine though. I'm not sure if the D-Link will be acknowledging QoS packets either. I have always found the best results for VoIP with Billion modems and routers. On Sat, Apr 5, 2008 at 11:29 PM, Voytek Eymont <[email protected]> wrote: > I have ADSL 512 with Sipura 3102, network is as follows: > Dlink ADSL modem 10.1.1.1 > Sipura 192.168.0.1 > BrandX WiFi 192.168.1.254 > > windoze xp > > Sipura's QOS is as: > QOS Policy: Always ON > QOS QDisc: None > Maximum Uplink Speed: 128 (Kbps) > > when windoze is downloading (like MS updates), VOIP becomes practically > unusable > > am I expecting too much from QOS ? on a 512ADSL ? > should I set QOS QDisc: to 'TBF' ? > > > -- > Voytek > > -- > SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/ > Subscription info and FAQs: http://slug.org.au/faq/mailinglists.html > -- SLUG - Sydney Linux User Group Mailing List - http://slug.org.au/ Subscription info and FAQs: http://slug.org.au/faq/mailinglists.html