Re: still can't compile term-readkey-pm5184 == it creates ReadKey.Bundle but then "no suitable image found" in ReadKey.bundle

So I looked at issue 461 and see that neider wrote:

For the record, I forced perl5184 on 10.15, symlinked perl5.18->perl5.18.4, and built term-readkey-pm5184 without any problems.

But I don’t know how to do this although it sounds simple.
1) How did he “force” perl5184?
2) where was the symlink performed?

Thanks, Hanspeter, for your help. Hope you can give a non-programmer some easy commands.

Tom

> On Nov 21, 2019, at 5:50 AM, Hanspeter Niederstrasser <[email protected]> wrote:
> 
> On 11/19/19 3:24 PM, Tom Liehe via Fink-beginners wrote:
>> 
>> Can't load 'blib/arch/auto/Term/ReadKey/ReadKey.bundle' for module Term::ReadKey: dlopen(blib/arch/auto/Term/ReadKey/ReadKey.bundle, 1): no suitable image found.  Did find:
>> 	file system relative paths not allowed in hardened programs at /System/Library/Perl/5.18/darwin-thread-multi-2level/DynaLoader.pm line 194.
>>  at /System/Library/Perl/5.18/darwin-thread-multi-2level/DynaLoader.pm line 98.
>> 	DynaLoader::croak('Can\'t load \'blib/arch/auto/Term/ReadKey/ReadKey.bundle\' fo...') called at /System/Library/Perl/5.18/darwin-thread-multi-2level/DynaLoader.pm line 194
>> 	DynaLoader::bootstrap('Term::ReadKey') called at ReadKey_pm.PL line 515
>> Creating ReadKey.pm
>> Bootstrapping the XS for blockoptions: make: *** [ReadKey.pm] Error 255
> 
> This is https://github.com/fink/fink-distributions/issues/461 <https://github.com/fink/fink-distributions/issues/461>
> 
> Hanspeter

_______________________________________________
Fink-beginners mailing list
[email protected]
List archive:
https://sourceforge.net/p/fink/mailman/fink-users/
Subscription management:
https://lists.sourceforge.net/lists/listinfo/fink-beginners