Re: Fink on Big Sur
Debbie Fligor <[email protected]>
| Newsgroups | gmane.os.apple.fink.beginners |
|---|---|
| Message-ID | <[email protected]> |
Hanspeter,
Thanks much, that downloaded and built with no problems on my 11.3.1 M1 mac mini (with a quick update to add the arm part to Bootstrap.pm).
I’m still not able to finish the fink self-update though, as it can never fine the sensible-utils file to download. I’m assuming there either isn’t one that supports arm, or it’s constructing the download url incorrectly, as it doesn’t matter which mirror, or if I issue the command by hand vs. the script, choose rsync or git, or anything else I’ve thought to try
curl --connect-timeout 30 -f -L -A 'fink/0.45.99.git' -O http://distfiles.master.finkmirrors.net/distfiles/sensible-utils-0.0.7.tar.gz
% Total % Received % Xferd Average Speed Time Time Time Current
Dload Upload Total Spent Left Speed
100 384 100 384 0 0 1811 0 --:--:-- --:--:-- --:--:-- 1811
0 0 0 0 0 0 0 0 --:--:-- --:--:-- --:--:-- 0
curl: (22) The requested URL returned error: 404 Not Found
It’s not (yet) a build issue, it can’t even download it. any ideas?
-debbie
> On May 18, 2021, at 16:16, [email protected] wrote:
>
> On 2021-05-18 13:35, Debbie Fligor wrote:
>> I’m stuck on the same thing in 11.3. I’m pretty sure that Hans’ mail
>> said it was just about done for Mac OS 11.1, Apple upped the perl
>> version for 11.3+ and it causing headaches.
>>> On May 18, 2021, at 13:15, Tom Liehe via Fink-beginners <[email protected]> wrote:
>>> Hi, FYI - I tried these steps on 11.4 beta and got:
>>> Writing updated configuration to '/opt/sw/etc/fink.conf'...
>>> plist is dpkg-bootstrap
>>> Sorry, this version of Perl (5.030002) is currently not supported by Fink.
>>>> On May 18, 2021, at 5:34 AM, Hanspeter Niederstrasser <[email protected]> wrote:
>>>> git clone https://github.com/TheSin-/fink
>>>> git checkout dpkg1.16
>>>> ./bootstrap
>
> My mistake. The changes for 11.3 haven't been merged yet to TheSin's location. To get the current draft of changes for 11.3 (which includes support for perl5.30.2), follow the above directions, but use this URL for cloning: https://github.com/nieder/fink
>
> Hanspeter
_______________________________________________
Fink-beginners mailing list
[email protected]
List archive:
https://sourceforge.net/p/fink/mailman/fink-users/
Subscription management:
https://lists.sourceforge.net/lists/listinfo/fink-beginners