extremely slow 'Scanning dists/stable/main/binary-darwin-x86_64' step on 10.13 with HFS

Jack Howarth <[email protected]> Fri, 10 Nov 2017 09:08:42 -0500

Newsgroups	gmane.os.apple.fink.devel,gmane.os.apple.fink.general
Message-ID	<CAP5Ds0DxHo78gL_mHRFi6LBgNLH-MLypT9Zxke7g_PNQN4oE0w@mail.gmail.com>

    Is anyone else on 10.13, booted from a hard drive formatted as a
HFS volume,observing the following behavior?  I am seeing an extremely
long delay during the final 'Scanning
dists/stable/main/binary-darwin-x86_64'step after building a package.
On 10.12, with a hard drive formatted as a HFS volume, this delay is
only a few seconds but under 10.13, I am seeing a 5-10 minute delay
during that step in fink.
                      Jack

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Fink-devel mailing list
[email protected]
List archive:
https://sourceforge.net/p/fink/mailman/fink-devel
Subscription management:
https://lists.sourceforge.net/lists/listinfo/fink-devel